Precautions for routine operation of laser cutting machine

- Jul 23, 2020-


Precautions for routine operation of laser cutting machine



1. The operator must strictly observe the safe operation rules of laser cutting machine.


2. The operator shall consult all the attached specifications or receive the training of our customer service personnel, be familiar with the structure and performance of laser cutting machine, and master the knowledge related to operating system.


3. Wear labor protection articles according to regulations, and wear protective glasses in accordance with regulations near the laser beam.


4. Do not process a material without knowing whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.


5. Operators shall not leave their posts or entrust others to take care of the laser cutting machine when it is in operation.


6. Keep a fire extinguisher at hand;Do not process to turn off the laser or light gate;Do not place paper, cloth, or other flammable material near an unprotected laser beam.


7. If any abnormality is found in the processing, the laser cutting machine should be stopped immediately, and the fault should be eliminated or reported to the supervisor in time.


8. Keep the laser, the bed and the surrounding site clean, orderly and oil-free, and the workpieces, plates and wastes shall be stacked in accordance with regulations.


9. When using gas cylinders, avoid damaging electric wires, water pipes and air pipes to avoid leakage of electricity, water and air.The use and transportation of gas cylinders should comply with the gas cylinder supervision regulations.Do not blow the cylinder in the sun or near a heat source.The operator must stand on the side of the bottle mouth when opening the bottle valve.


10. Before opening the water cooling electromechanical source, check the water cooling machine's water level. It is strictly prohibited to open the water cooling machine when there is no water or the water level is too low, so as to avoid damaging the water cooling equipment.Water cooler inlet and outlet water pipe is strictly prohibited to crush, trample, keep waterway smooth.


微信图片_20200527105800~1




11, laser cutting machine in cutting some plates will produce a lot of smoke and dust, should be the fan out of the air pipe to the outdoor, or add air purification device.In addition, operators should wear dust masks to prevent the occurrence of occupational diseases.

12. When the air temperature is shut down for a long time below 0℃, the cooling water in the water cooler, laser and waterway pipe shall be released to avoid freezing of the cooling water under too low temperature, which will cause damage to the laser cutting machine and pipeline.

13. Check the protective lens inside the laser cutting head once a day.When the collimating mirror or focusing mirror needs to be removed, record the removal process, especially pay attention to the installation direction of the lens, do not install wrong




Previous:Advantages of laser cutting compared with other thermal cutting methods Next:​Application of laser cutting machine in fitness equipment industry