What are the common faults of optical fiber laser cutting machine in daily use
Due to many customers in the process of using optical fiber laser cutting machine, due to improper operation and other reasons, the laser cutting machine has some minor faults. Although these faults are not big, they will cause delays and even losses to the normal use period. Therefore, it is extremely urgent to understand the common faults of optical fiber laser cutting machine.
1. When we start up and operate the laser cutting machine, it has no action, which is what we should do
1) Check whether the parameters of the main board of optical fiber laser cutting machine are correct. If there is any error, please refer to the software instructions.
2) Of course, before checking these, check whether the equipment is powered on.
2. When the optical fiber laser cutting machine is working normally, there is suddenly no laser
1) First check whether there is deviation in the optical path of the optical fiber laser cutting machine. If there is deviation, it is ok to adjust the optical path
2) If there is a problem with the line of optical fiber laser cutting machine, the point ray with the laser cutting machine should be plugged into the signal port of the power supply for judgment at this time
3, the optical fiber laser cutting machine in the normal work of the laser intermittently
1) First check whether the water circulation of the laser cutting machine is unobblocked. If there is a blockage, clean the water tank, water pump and water pipe.
2) Secondly, check whether the voltage supplied by the equipment is stable. If the power supply is unstable, this kind of problem will be triggered
4. The optical fiber laser cutting machine cannot process the online data
1) First check whether the communication data line of the optical fiber laser cutting machine is in good condition. If not, please shut down and reconnect the communication data line first
2) Check whether the software USB installation is successful. If it is shown that the installation fails, please re-install the software and USB driver
5. There is a problem with the size data
1) Restore the original parameters of the installation and its original software